The Ant - Compact PCB Maker

The Ant - Compact PCB Maker

The Ant was a successful project. So successful we never got round to make a blog post about it. The project now seems to have run it's course. Some parts have become obsolete and hard to get a hold of. Why highlight it then now? It is a classic good MakerBeam project where MakerBeam is used to frame items that are (or were) ready available and custom 3D printed items.

 

 

The Ant team also made a series of how to build the Ant step by step in a series of videos. The 200mm (b: 100900, c: 100180) and 60mm (b: 100067, c: 100157) MakerBeam (10x10mm), T-slot nuts (101619), right angle brackets (100326), square headed bolts 6mm (100359) and the 200mm linear slide (104162) and self locking nuts (101619) are all needed for the build and they go through all the steps. You can find these here below.

 

 

The Ant team also made a series of how to build the Ant step by step in a series of videos. The 200mm (b: 100900, c: 100180) and 60mm (b: 100067, c: 100157) MakerBeam (10x10mm), T-slot nuts (101619), right angle brackets (100326), square headed bolts 6mm (100359) and the 200mm linear slide (104162) and self locking nuts (101619) are all needed for the build and they go through all the steps. You can find these here below.

 

 

The Ant team obviously is passionate about electronics. Two of them, Matti and Angelo, have gone on to create videos on the channel Due Makers Asociali (Italian language).

 

Comments

Be the first to comment...

Leave a comment
* Your email address will not be published